Setup guide

<emulator_input_delay>, <audio_input_delay>, <audio_output_delay>,
<video_precision (8 to 10 bits)>
Is:Where:
The name for the emulator.
<name>
The video input format. For a list of the video formats supported by your
workstation, see Video on page 73.
<input_format>
The video resolution and timing of the VTR to be emulated.
<timing>
The colourspace mode for video transfers.
<colorspace_mode>
The video output format. For a list of the video formats supported by your
workstation, see Video on page 73.
<output_format>
The source used to synchronize the video output. By default, this value is set
to Autodetect.
<output_sync>
The serial port to which the VTR control cable is connected.
<serial_port>
The video output delay used by the emulator in frames.
<emulator_output_delay>
The video input delay used by the emulator in frames.
<emulator_input_delay>
The audio input delay used by the emulator in frames.
<audio_input_delay>
The audio output delay used by the emulator in frames.
<audio_output_delay>
The interface precision used for video transfers.
<video_precision>
Examples of use
Emulator sony, NTSC, SERIAL1, NTSC, YCBCR_RGB_CONVERSION, SERIAL1, HOUSE,
AJA:0:1,-5, 1, 0.00, 0.00, 8
Emulator sony, HSDL 1499 sf, SERIALDUAL, 2048x1556_1499SF, NO_CONVERSION,
SERIALDUAL, STANDALONE, AJA:0:1, -6, 1, 0.00, 0.00, 10
Audiodevice
The Audiodevice keyword initialises the specified audio device.
The Audiodevice keyword uses the following syntax
AudioDevice <type>
where <type> is currently AJA.
AJA specifies that the audio subsystem is part of the AJA audio/video I/O device, respectively. Note that for
the audio to work, the Video keyword must be configured with the corresponding video device.
Example of use
Audiodevice AJA
Audiodevice | 79