Setup guide

2 Depending on the result of the previous command, do one of the following:
■ For clips with frames listed as missing, contact your local Autodesk support representative for help
on resolving this issue.
■ For clips with frames listed as remote, perform the following procedure.
To recover remote frames:
1 Archive all clip libraries that are reported as containing remote frames. In the previous example, the
fourth library (from_caplan) contains remote frames.
2 Rename the libraries you just archived, such as by adding the remote suffix to the library name.
3 Restore the clip libraries from the archive. All the frames referenced by the clips should now be stored
locally.
4 Delete the original libraries.
Verifying that the Disks are Available to the Operating System
If your disks or logical drives are not visible in the output of the sw_df command, verify that they are visible
to the operating system.
1 Run the command that will provide you with a list of all the controllers or disks on your system. cat
/proc/scsi/scsi. A listing of all controllers and hard disks attached to your system appears.
2 If any controllers or hard disks in your configuration are not visible, check the connections and cabling
to your storage device, and ensure that your storage hardware is running.
If you must reconnect or tighten connections to your storage hardware, it is a good idea to rescan your
hardware to ensure that the operating system is able to communicate with it.
1 Unload the Stone and Wire driver: /etc/init.d/stone+wire unload
2 Unload and reload the fibre channel drivers. Type one of the following sequence of commands,
according to your fiber channel card model.
■ If you have a QLogic-based card, type:
rmmod qla2300
rmmod qla2400
rmmod qla2xxx
rmmod qla2xxx_conf
modprobe qla2xxx
modprobe qla2300
modprobe qla2400
■ If you have an ATTO-based card, type one of the following sequences of commands:
For HP Z800 workstations, type:
rmmod celerity8fc
modprobe celerity8fc
For older HP workstations, type:
rmmod celerityfc
modprobe celerityfc
NOTE Depending on the storage you are running, your system might not use all of the drivers listed. If your
system does not use a driver listed, the commands to unload or reload the drivers will fail. You can ignore
these failures. They just indicate that the driver is not required by your system.
Advanced Configuration and Troubleshooting | 81