Setup guide

./INSTALL_LICSERV
The license server is installed.
8 Once you have received the license codes, go to the
/usr/discreet/licserv/licenses/ directory, and open the DL_license.dat file in
a text editor.
NOTE If the file does not exist, create it by typing:
touch /usr/discreet/licserv/licenses/DL_license.dat
9 In this file, enter all the information submitted to you by the Licensing
Department upon your registration.
10 Save and close the file.
11 Start the license server by running the following command:
/etc/init.d/license_server start
NOTE The license server starts/stops automatically when the machine is
booted/shut down. You can stop and restart the server manually by running
one of the following commands:
/etc/init.d/license_server stop
/etc/init.d/license_server start
Now that the license server is set up, configure each node to contact the server
and retrieve its license. Perform the following procedure on each node.
To enable render nodes to contact the license server:
1 Log in to each render node as root.
2 Navigate to the license directory. Type:
cd /usr/local/flexlm/licenses/
3 Open the DL_license.dat file in a text editor.
4 In this file, copy the first three lines of the information submitted to
you by the Autodesk Licensing Department upon your registration. For
example:
SERVER burn-01
DLHOST01=25231AEF83AD9D5E9B2FA270DF4F20B1
VENDOR lustre
USE_SERVER
5 Save and close the file.
Configuring Lustre Background Rendering | 89