Setup guide

The installation package is unpacked into a new directory. Navigate to
the new directory.
4 Start the installation script by typing:
./INSTALL_LUSTRE_SLAVE
The Slave Renderer is installed.
To install the Slave Renderer license:
1 If you have not already done so, obtain a license for the Slave Renderer.
You will need the dlhostid of the Slave Renderer. See Requesting License
Codes (page 100).
2 Log in to the Slave Renderer as root.
3 Create the directory for the license file. Type:
mkdir -p /usr/local/flexlm/licenses/
4 Create a file called DL_license.dat using a text editor such as nedit, and
save it to the new directory. Type:
nedit /usr/local/flexlm/licenses/DL_license.dat
NOTE The license directory and filename are case-sensitive and must be
created and named exactly as specified.
5 Copy the license code you received for the Slave Renderer from Autodesk
to the DL_license.dat file.
Configuring Read/Write Access to Storage from
the Slave Renderer
The storage must be exported from the Master Station in order to allow
read/write access. This, in turn, makes it possible for the Slave Renderer to
remotely mount the storage system.
NOTE You do not need to perform the tasks in this section if you are using the
BrowseD service with the Slave Renderer. See Using BrowseD with the Slave Ren-
derer (page 97).
74 | Chapter 4 Configuring Your Software