Setup guide

2 If you need to change your system date or time, do it before installing
the application.
3 Go to the application installation directory. You must mount the USB
key (page 42) or extract the tar file (page 43) to access the install
directory.
4 Start the application installation script by typing:
./INSTALL_LUSTRE
5 If prompted with a message asking if you would like to automatically
run Backburner
™
Server on this machine, click Yes.
The Lustre application, as well as supporting software (Backburner,
Wiretap, Wiretap
®
Gateway, the BrowseD server) are installed. A new
user account is created for the version of Lustre you just installed. Read
the following chapter for information on licensing and starting your
application for the first time.
NOTE If you are upgrading to a service pack of the same release or extension,
you do not need to re-license your software.
6 Prior to licensing and starting the application for the first time, perform
the post-installation procedures necessary for your system.
Uninstalling your Software
The Autodesk Software Remover utility enables you to easily uninstall Autodesk
Creative Finishing applications from your workstation.
To uninstall your application:
1 If you are logged in as the application user in KDE, log out and log back
into KDE as root.
2 From the KDE menu, select Autodesk > Remove Software.
The user interface appears.
Uninstalling your Software | 57