Setup guide

./install.pl
5 Choose option 4 in the main menu.
6 Type Y when asked if you want to configure ib0.
The current configuration is displayed. For example:
DEVICE=ib0
BOOTPROTO=static
IPADDR=10.10.11.3
NETMASK=255.255.255.0
NETWORK=10.10.11.0
BROADCAST=10.10.11.255
ONBOOT=yes
7 Type Y to change the configuraton.
8 Enter the new IP address, netmask, broadcast address and base network
address for the InfiniBand port.
The settings are saved in the /etc/sysconfig/network-scripts/ifcfg-ib0 file,
and you are returned to the main menu.
9 Type Q to exit the configuration utility.
10 Reboot your workstation.
To configure the IP address for a QLogic DDR InfiniBand card:
1 If the InfiniBand card was not installed into your workstation when you
last upgraded the DKU, re-run the DKU installation script to setup the
drivers for the InfiniBand card.
2 Open a terminal and log in as root.
3 Run the Silverstorm InfiniBand configuration utility:
/sbin/iba_config
4 Choose option 2 in the main menu.
5 Follow the on-screen instructions to configure the IP address of the
InfiniBand card.
The settings are saved in the /etc/sysconfig/network-scripts/ifcfg-ib1 file,
and you are returned to the main menu.
6 Type X to exit the configuration utility.
7 Reboot your workstation.
Installing Red Hat Enterprise Linux or CentOS and the DKU | 41