Setup guide

192.168.0.150 flame1
6 Save and close the file.
To configure DNS server information:
1 Open the /etc/resolv.conf file in a text editor.
2 Add a line for each DNS server IP address you want to use. The syntax
is:
nameserver <DNS_server_IP>
For example:
nameserver 22.10.50.101
nameserver 22.10.50.102
NOTE Be careful when editing the resolv.conf file. The syntax is very strict,
and any extra spaces or carriage returns can render the file unusable by the
system.
Configuring an InfiniBand Card
If your workstation is equipped with a Mellanox QDR InfiniBand / 10 GigE
adapter card, or a QLogic 9000 DDR InfiniBand adapter card, perform the
procedures in this section to configure the IP address of the Infini|Band port.
NOTE Install the DKU before performing the procedures in this section. If the
Mellanox or QLogic InfiniBand adapter card is present in the workstation when
the DKU is installed, the drivers are automatically installed and configured by the
DKU. If you add an InfiniBand card to your workstation after having installed the
DKU, run the DKU installer again to configure the required drivers.
To configure the IP address for a Mellanox QDR InfiniBand card:
1 If the InfiniBand card was not installed into your workstation when you
last upgraded the DKU, re-run the DKU installation script to setup the
drivers for the InfiniBand card.
2 Open a terminal and log in as root.
3 Navigate to the OFED Distribution directory:
cd /usr/discreet/DKU/InfiniBand/ofed*
4 Run the OFED Software Installation script:
40 | Chapter 2 Preparing your Workstation