Setup guide

4 Start Lustre. The following message should appear in each Console:
Panel #<panel_ID> is detected
This confirms that the Autodesk Control Surface is enabled.
Installing Red Hat Enterprise Linux or CentOS and
the DKU
Do I Need to Reinstall Linux?
Your workstations ship with the correct Autodesk distribution of Red Hat
Enterprise Linux already installed and configured. Thus, you should only need
to install Linux in the following situations:
■ You plan to upgrade your software on an older supported hardware
platform running a version of Red Hat Enterprise Linux no longer supported
by the current version of the software. In this case, you must perform a
fresh install of the required Red Hat Enterprise Linux version.
■ Your system experienced an unrecoverable hard disk failure and you had
to replace the system disk.
NOTE If you must replace the hard disk of your workstation, you need to obtain
a new license. Contact Customer Support for assistance.
Use the following table to determine the correct version of Red Hat Enterprise
Linux required for your hardware platform.
Linux VersionHardware Platform
Custom Autodesk distribution of Red Hat Enterprise Linux Desktop
5.3 with Workstation Option
HP Z800
Custom Autodesk distribution of Red Hat Enterprise Linux WS 4,
Update 3
HP xw8400,
HP xw9400,
HP xw8600
To determine the version of Red Hat Enterprise Linux your system is currently
running, open a terminal and type:
Installing Red Hat Enterprise Linux or CentOS and the DKU | 33