Setup guide

Assigning an IP Address to the Autodesk Control Sur-
face
You must assign an IP address and subnet mask to the Autodesk Control
Surface.
Assign the network port connected to the control surface with a static IP
address that does not interfere with any of the IP addresses on your network.
To configure the Autodesk Control Surface:
1 Type:
nedit /etc/sysconfig/network-scripts/ifcfg-eth<port#>
2 Modify the IPADDR and NETMASK values. For example:
IPADDR=192.168.125.10
NETMASK=255.255.255.0
Configuring Lustre to Connect to the Autodesk Control
Surface
Before you can configure Lustre to connect to the Autodesk Control Surface,
Lustre must be installed, either as a standalone install (page 56) or as part of
a Flame Premium install (page 53).
To configure Lustre to use the Autodesk control surface:
1 Turn the power on to each of the modules and look at the top display
panel on the module. It should display the panel name and ID.
2 After you install Lustre, open the init.config file located in
/usr/autodesk/<lustre_version> with a text editor.
3 In the ControlSurface section of the init.config file of your project, enter
the panel IDs for each panel.
ControlSurface
AutodeskPanels state=”On”
PanelIDs function=”<panel_ID>” grading=”<panel_ID>”
navigation=”<panel_ID>”
32 | Chapter 2 Preparing your Workstation