Setup guide

This section provides information on making the physical connections needed
to operate the Autodesk Control Surface. For information on using the Control
Surface, see the Autodesk Control Surface User Guide.
NOTE
The illustration shows the central panel only (the Colour Grading panel). This
panel is easily identified, since it has both an Ethernet network port and a
USB connector. It is also the panel with the built-in tablet.
To connect the Autodesk Control Surface:
1 Connect each panel to a power supply using the AC power adapter cables.
2 Use network cables to connect each panel to the available ports in the
network switch.
3 Connect the Colour Grading panel to the remote unit of the USB
extender kit.
4 Use a network cable to connect an available port on the Netgear network
switch to the workstation, as illustrated.
Setting Up Your Workstation Hardware | 31