Setup guide

provide are a sync generator, VTR, HD/SDI-ready broadcast monitor and patch
panel (if desired).
1 Connect the output of the sync generator to the top Ref Loop port of
the AJA K3G-Box.
2 Connect the Input port of the NVIDIA SDI card (the one next to the
DVI port) to the bottom Ref Loop port of the AJA K3G-Box.
3 Connect the Fill (outer) port of the NVIDIA SDI card to the Input port
of the AJA HD5DA distribution amplifier.
4 Connect one of the OUT ports of the distribution amplifier to an SDI
IN port of the broadcast monitor.
5 For RTD or Stereo, connect another OUT port of the amplifier to the
Link A input port of the VTR.
6 For Stereo or RTD, connect the Key (middle) SDI port of the NVIDIA
SDI card to the Link B input port of the RTD VTR.
7 Connect the RS-422 port of the AJA K3G-Box to the VTR control port.
8 If not using RTD, connect SDI OUT A, SDI OUT B, SDI IN A and SDI
IN B ports of the VTR to the SDI1, SDI2, SDI3 and SDI4 ports on the
front of the AJA K3G-Box.
16 | Chapter 2 Preparing your Workstation