Setup guide

4 Click a port to view information and statistics on it.
NOTE If you have ports with DDR connections that appear to be running
at SDR speed (2.5 Gbps instead of 5 Gbps), unplug the cable and then plug
it back in. The connection should run at normal DDR speed afterwards. This
issue occurs because of a bug in the switch firmware.
Viewing Port Statistics for an InfiniCon InfinIO 9024
Switch
The InfinIO 9024 InfiniBand switch is the recommended switch model for
DDR InfiniBand networks.
The InfinIO switch comes with a Web-based application, the InfiniView Device
Manager
™
, that you can use to configure, monitor, and manage the InfiniBand
network.
When you suspect that performance is not optimal on your QDR switch, it is
a good idea to view statistics for each connected port, to determine if they are
running normally. The nominal speed for DDR InfiniBand connections is 5
Gbps.
To access the Device Manager, your browser must be on the same subnet as
the InfiniBand switch, which has a default IP address of 10.10.10.252.
To view switch port statistics:
1 Open a Web browser and enter the IP address of the InfiniBand switch,
usually 10.10.10.252.
The main page of the Device Manager appears.
Visual Effects and Finishing Troubleshooting | 235