Setup guide

■ If the search returns no results, the problem is not related to invalid
frame references. Read the /usr/discreet/sw/log/sw_dbd.log file to
determine the cause of the problem.
3 Stop Stone and Wire by typing:
/etc/init.d/stone+wire stop
4 Clean up the Stone and Wire database by typing:
/usr/discreet/sw/sw_dbd -C
A message is displayed in the terminal asking you to confirm the deletion
of invalid entries from the database.
5 Type Y to confirm the operation.
Invalid entries are removed from the Stone and Wire database.
6 Restart Stone and Wire by typing:
/etc/init.d/stone+wire start
Troubleshooting Wire Network Problems
This section describes some common Wire problems and steps you can take
to solve them.
Testing Wire Using sw_framestore_dump
Use sw_framestore_dump to identify the Wire hosts that are reachable from
one workstation. You should do this if you are having any problems with
Wire or after you configure Wire for the first time.
NOTE You must have at least two Wire hosts set up to test Wire connectivity.
To verify that you can access the framestores on other Wire hosts:
1 Type:
/usr/discreet/sw/tools/sw_framestore_dump
A list of all the available framestores appears in the terminal. Review the
output and verify that all the framestores on your Wire network appear
in the list.
226 | Chapter 6 Advanced Configuration and Troubleshooting