Setup guide

ls -altr
Enabling Verbose Stone and Wire Driver Error Report-
ing
Use the swr_set_debug utility to enable verbose reporting of Stone and Wire
driver errors.
When you turn on error reporting, Stone and Wire outputs error messages in
the following locations:
■ /var/log/messages
■ Console window
NOTE You must disable verbose error reporting after you have finished
troubleshooting. The messages generated by this process can fill up the system
drive.
To enable verbose Stone and Wire driver error reporting:
1 Run swr_set_debug. Type:
/usr/discreet/sw/tools/swr_set_debug<level>
where <level> is the number representing the verbosity of the report.
Choose from one of the following levels:
■ 1 - Turns on error reporting. This is the default level.
■ 2 - Provides more detailed reporting. All operations and errors are
logged.
■ 0 - Disables error reporting.
2 Check the terminal and the log files for error information.
Troubleshooting Missing Frames
If the application cannot find some of the frames referenced by your clips,
the following error message is displayed when the application starts:
■ In the terminal:
Visual Effects and Finishing Troubleshooting | 219