Setup guide

Starting Stone and Wire Processes
All Stone and Wire processes should start when you restart your system. If
they are not running, check that they are configured to run and then restart
Stone and Wire. To start Stone and Wire processes, you must modify a text
file listing all processes.
To start Stone and Wire processes:
1 Use a text editor to open the Stone and Wire configuration file
/etc/sysconfig/stone+wire.
The file should include the following:
dl_stone=on
dl_wire=on
dl_wiretap=on
dl_vic=on
If any of the processes you need are set to “off”, change them to “on”
and then restart Stone and Wire.
2 To restart Stone and Wire, type:
/usr/discreet/sw/sw_restart
If any Stone and Wire process is still not running, check the error logs.
Checking Stone and Wire Error Logs
Every Stone and Wire process has a log file. You can find these log files at
/usr/discreet/sw/log.
The current log file is named <process>.log, where <process> is the name
of the Stone and Wire process or daemon. The next time Stone and Wire
creates a log file for the process, it renames the previous log file by adding a
number to the file name.
For example, the sw_served process log file is named sw_served.log. The next
time the process is launched, the first log file is renamed to sw_served.log.1.
Each time Stone and Wire creates a new log file, the old log file is renamed
by incrementing the number that appears at the end of the filename.
You can also use the terminal to list the most recent version of the log files.
Type the following in a terminal:
218 | Chapter 6 Advanced Configuration and Troubleshooting