Setup guide

FunctionDefaultData typeParameter
The IP address or DNS host name
for a specific Wiretap Gateway
server.
0.0.0.0String<WiretapGatewayServer>
(within <WiretapGate-
wayServer Group>)
Allows you to map hostnames to
IP addresses, as well as to define
path translation rules.
0.0.0.0String<PathTranslation>
(within <PathTranslationT-
able>)
Applies the correct aspect ration to
NTSC resolution footage rendered
1.3333333333333Float<NTSCImageAspectRatio>
to the Wiretap server, but not im-
ported from the Wiretap server.
Applies the correct aspect ratio to
PAL resolution footage rendered to
1.3333333333333Float<PALImageAsepectRatio>
the Wiretap server, but not impor-
ted from the Wiretap server.
<MonitoringAndCalibration>
Specifies the monitor display type
(e.g., LCD or CRT).
LCDEnumerated
(abstract
data)
<DisplayType>
Specifies the number of monitor
calibration steps performed.
10Integer<Calibration_Steps>
<ControlSurface>
When ON, this keyword enables
the Autodesk Control Surface
OnState<AutodeskPanels>
(ACS). When OFF, Lustre enables
the Tangent CP100 control surface
(if applicable).
You must also set the path for the
control surface rules file in the
Panel Setup File field (refer to “Sys-
Lustre Software, Project, and User Configuration Files | 169