Setup guide

Keyword ExampleProject Resolution
Hires Custom, 30HzCustom
VideoPreviewWindow
The VideoPreviewWindow keyword is used when using a Miranda DVI-Ramp
device. It locates a preview device that has a matching size and refresh rate in
the VideoPreviewDevice list specified in the init.cfg configuration file. When
you start the application or switch to another project from the application,
the graphics-to-video display is mapped to the appropriate device according
to the width, height, and refresh rate specified with this keyword.
The VideoPreviewWindow keyword uses the following syntax
VideoPreviewWindow <xsize>, <ysize>, <refresh_rate>
Is:Where:
The horizontal and vertical size of the area of the image window
output to the graphics-to-video display.
<xsize>, <ysize>
The refresh rate of the output.<refresh_rate>
Example of use
VideoPreviewWindow 720, 486, 30
ArchiveLibrary
Online HTML and ASCII tables of contents will be saved to the filesystem.
You can specify the destination directory by setting this keyword. Its default
value is /usr/discreet/archive. You can make the target directory relative to the
project directory by prefixing the path with a tilde (e.g. ~/archive).
NOTE This keyword, if set, will take precedence over the ArchiveLibrary
keyword in the init.cfg file.
158 | Chapter 6 Advanced Configuration and Troubleshooting