Setup guide

device. The following table shows the colourspace conversion methods that
are available for single-link and for dual-link I/O connections.
Supported for Dual-Link
Serial (4:4:4) I/O
Supported for Single-Link
Serial (4:2:2) I/O
Colourspace Conversion Meth-
od
NoYesYCbCR -> RGB
NoYesYCbCR -> RGB + Headroom
YesNoNo Conversion
YesNoNo Conversion + Headroom
Emulator
Use the Emulator keyword to enable the VTR Emulation feature and configure
your workstation to emulate a Sony
™
VTR that is controllable via the RS-422
serial port. For help configuring the hardware for VTR emulation, see the
hardware setup guide for your workstation.
The VTR Emulation feature supports SD and HD video timings. This feature
is available in Smoke Advanced.
You can specify more than one emulator. Any enabled emulator can be selected
for a project, regardless of the project's video I/O timings.
The Emulator keyword uses the following syntax
Emulator sony, <name>, <input_format>, <timing>,
<colorspace_mode>, <output_format>, <output_sync>,
<serial_port>, <emulator_output_delay>,
<emulator_input_delay>, <audio_input_delay>,
<audio_output_delay>, <video_precision (8 to 10 bits)>
Is:Where:
The name for the emulator.<name>
The video input format. For a list of the video formats supported
by your workstation, see Video (page 129).
<input_format>
Visual Effects and Finishing Configuration Files | 137