Setup guide

Is:Where:
directly to cue the VTR. Use vtrff if using vtrcueing causes the
VTR to react slowly when cued, such as with a Betacam SP
™
.
The delay in milliseconds after a vertical sync, before requesting the
VTR timecode. This value should only be set or changed with the
help of technical support.
NOTE The value '99' is a special case to be used strictly with HDCAM-
SR/720P and AJA. It is not to be used in other circumstances unless
specified by technical support.
<TC_transition_delay>
The delay in frames before the edit sync point to send the ON
command. This parameter is optional and it applies only to BVW50.
<edit_on_delay>
The delay in frames before the edit sync point to send the OFF
command. This parameter is optional and it applies only to BVW50.
<edit_off_delay>
The delay in milliseconds before the application sends certain com-
mands to the VTR. This parameter is optional, but useful for older
VTRs such as the BTS.
<vtr_command_delay>
NOTE The init.cfg file contains a comprehensive list of Vtr keyword examples for
supported devices. In most cases you just have to uncomment the lines for the
device that you want to use. In some cases minor changes to parameters are
required.
Configuring Colourspace Conversion for Device I/O
When you set the input or output format for a device in the Vtr keyword,
you should also specify its colourspace conversion method using the
<colorspace mode> parameter. The supported conversion methods depend
on whether a single-link or dual-link connection is used for I/O with the
136 | Chapter 6 Advanced Configuration and Troubleshooting