Setup guide

TIP This directory contains an extensive list of templates for all supported display
environments, some of which may not be suitable for your workflow. To make
template selection easier, use the mkdir command to create a directory called
unused in the directory /usr/discreet/<product_home>/cfg/linux-x86_64/template.
Use the mv command to move templates you do not use to this folder. When
you use the Create Project menu, only those templates that remain will be available.
Select the template from the following table that corresponds to the resolution
of your project.
Sets parameters for projects to work with:The configuration file template:
NTSC 601 material. The external sync source is NTSC black-
burst.
ntsc.cfg
PAL 601 material. The external sync source is PAL blackburst.pal.cfg
24p material of any resolution.24p.cfg
Film-based material that has been transferred to NTSC 601
video. The external sync source is NTSC blackburst.
24p_ntsc.cfg
Film-based material.film.cfg
Film-based material that has been transferred to NTSC video.
The external sync source is NTSC blackburst.
film_ntsc.cfg
Film-based material that has been transferred to HD video.
The external sync source is NTSC blackburst.
[e-mail]
[e-mail]
24p_1280x720@5994p_free.cfg
[e-mail]
24p_1280x720@6000p_free.cfg
[e-mail]
The corresponding HD standard on workstations to which
no external sync source is connected.
1280x720@5994p_free.cfg
1280x720@6000p_free.cfg
1920x1080@23976psf_free.cfg
1920x1080@24000psf_free.cfg
1920x1080@25000psf_free.cfg
1920x1080@50i_free.cfg
124 | Chapter 6 Advanced Configuration and Troubleshooting