Setup guide

Using BrowseD for Rendering with Burn for

Lustre

You must configure the Lustre Render Backburner paths with the IP address

of the BrowseD server to use BrowseD to render with Burn for Lustre.

To use BrowseD for rendering with Burn for Lustre:

1 In Lustre, open the Setup menu, and select Settings.

2 Select your project from the Project list, and click Edit.

3 Click Project, and set the local project paths. For information on

configuring your projects, see the Autodesk Lustre User Guide.

4 Click Network Rendering, and then click the Backburner tab.

5 Enter the IP address of the BrowseD server to each path, or click the

ellipsis button to browse to the BrowseD path you want to use.

For example, if your Project_Home is set to the bernicedirectory on the

mount point /mnt/StorageMedia of a station that has an IP address of

172.17.20.146, the Project_Home path in the Render > Backburner menu

should read 172.17.20.146: /mnt/StorageMedia/project/bernice.

Using BrowseD with the Slave Renderer

You must configure the Lustre Slave Render paths with the IP address of the

BrowseD server in order to use BrowseD with the Slave Renderer.

To use BrowseD with the Slave Renderer: