Setup guide

DescriptionCommand
Restarts BrowseD if it is not currently running./etc/init.d/browsed_<version>restart
Restarts BrowseD if it is already running./etc/init.d/browsed_<version>condrestart
Configuring Workstations to Use the BrowseD
Server
You must configure the init.config file for all machines that will use the BrowseD
server to access centralized storage, such as Lustre workstations, slave renderers,
or Burn render nodes.
Use a text editor to edit the init.config file, located at /usr/autodesk/<version>.
Use the following table as a reference when configuring the init.config file.
Required valuesKeyword
Enter the administrative user on the BrowseD server, for example, root on
Linux.
Username
Enter the password for the administrative user as defined above.Password
All computers on the BrowseD network must use the same port to communic-
ate. Set to 1055, the default. If configuring a render node or a workstation
Port
running on a GigE network, set this as 1044. If configuring a render node or
a workstation running on a high-speed InfiniBand network, set this as 1055.
Defines the IP address or DNS host name for a specific BrowseD Server.BrowsedServer
Enable this option if the networking procotol to use with BrowseD is InfiniBand.UseInfi
Configuring Lustre BrowseD | 95