Setup guide

Perform the steps in the procedure below to set up an optimal bandwidth reservation for the local application,
as well as for remote workstations, based on your system configuration.
To set up bandwidth reservation:
1 Open a terminal and log in as root.
2 Open the /usr/discreet/sw/cfg/sw_bwmgr.cfg file in a text editor.
3 Locate the [Device] section that corresponds to the standard filesystem partition (by default [Device0]),
and uncomment it if it is commented out.
4 Add a Reservation line for each local or remote application, using the following syntax:
74 | Chapter 2 Install and configure a Flare workstation