Setup guide

IPADDR="192.168.1.100"
NETMASK="255.255.0.0"
ONBOOT="yes"
GATEWAY=192.168.0.1
You'll need the following from your network administrator:
■ A unique static IP address and host name for your system
■ The network gateway IP address.
■ The subnet mask of your network.
■ DNS server IP address(es).
Configure an InfiniBand card
If the card was not present when you last ran the DKU installation, run it again to setup the drivers for the
card. After changing the configuration, you must reboot for them to take effect.
If your workstation is equipped witha Mellanox QDR InfiniBand / 10 GigE adapter card, or a QLogic 9000
DDR InfiniBand adapter card, perform the procedures in this section to configure the IP address of the
Infini|Band port.
Mellanox QDR InfiniBand / 10 GigE adapter card
■ Settings are stored in /etc/sysconfig/network-scripts/ifcfg-ib0
■ You can update the file by running, as root, the script /usr/discreet/DKU/InfiniBand/ofed/install.pl
■ You may need to edit the IP address, netmask, broadcast address and base network address.
QLogic DDR InfiniBand card
■ Settings are stored in /etc/sysconfig/network-scripts/ifcfg-ib1
■ You can update the file by running, as root, the script /sbin/iba_config
■ You may need to edit the IP address.
Install the DKU and the AJA OEM-2K firmware
Check the DKU version
In a terminal, as root, check the currently installed DKU version with the command head -n1
/etc/DKUversion. If the version does not meet the requirements for the new application version, install the
DKU.
Install the DKU
WARNING Do not attempt to install the current version of the DKU on unsupported platforms, including older
Creative Finishing systems. This will result in the installation script only installing a generic configuration which
can render your operating system unusable.
To install the DKU:
1 Prepare the installation media (page 31).
22 | Chapter 1 Flame Premium Installation and Configuration