Specifications

iv
Appendix B
0 1 0 3 1 Online
0 2 2 0 0 Online
0 3 3 0 0 Online
0 4 xx xx xx 4500
0 5 xx xx xx Offline
0 6 xx xx xx Offline
..
0 30 xx xx xx Offline
0 31 xx xx xx Offline
xx xx 0 7 0 Reserved
Ready.
set RouteOffline 0 0
Ready.
get RouteOffline 0 0
;fp fl sb st sl On/Offline
0 0 0 3 0 Offline
Ready.
set FibreBridgeTargetLUN 0 0
Ready.
get RouteOnline 0 0
;fp fl sb st sl On/Offline
0 0 xx xx xx 4500
Ready.
get FibreBridgeTargetLUN 0
2
;fp fl
0 0
Ready.
set ScsiInitId 0 0
Ready.
get ScsiInitId 0
Port 0 ScsiInitId = 0
Ready.
RouteDisplay 0 1
3
;fp fl sb st sl On/Offline
0 1 xx xx xx Offline
xx xx 0 7 0 Reserved
AutoMap Command Sequences
The following are examples of typical command
sequences used in issuing an AutoMap command.
Both the actual commands as well as their output
to the Services port are shown.
Ready.
ScsiPortList
2
;SCSI Port Port Status
0 O.K.
Ready.
FcPortList
2
;Fibre Port Port Status
0 O.K.
Ready.
RouteDisplay online
3
;fp fl sb st sl On/Offline
0 0 0 0 0 Online
0 7 xx xx xx 1180
xx xx 0 7 0 Reserved
Ready.
AutoMap
Setting device offline: FC 0 Lun 0.
Setting device offline: FC 0 Lun 1.
Setting device offline: FC 0 Lun 2.
Setting device offline: FC 0 Lun 7.
Scanning SCSI bus 0
SCSI bus 0 scan complete.
Ready.
RouteDisplay online
6
;fp fl sb st sl On/Offline