Specifications

ii
Appendix A POST information
POST
, or power-on self test, is a set of routines which tests various system components to see if they are
properly connected and operating. The display appears on the host after power is applied to the
FibreBridge 1180E/D connected to it. Type
menu
to enter the menu system: type
help
for a list of CLI
commands.
ATTO FibreBridge 1180
Stepping test Passed
Onchip memory test Passed
Error log empty
00000040 MB of SDRAM installed
SW Opt Jumper = 00000040
Dram walking bit test Passed
Dram 1 and 0 test Passed
Dram address test Passed
Testing FibreChannel Port 0...
ISP2200 Configspace test Passed
ISP Reset test Passed
ISP Reg Read/Write test Passed
ISP Mailbox test Passed
ISP SRAM test Passed
ISP SRAM Address test Passed
ISP Master 00010002 test Passed
ISP Master 5555aaaa test Passed
ISP Master 0000ffff test Passed
Testing SCSI Port 0
SYM895A Configspace test Passed
SYM895A Reg R/W test Passed
SYM895A Revision test Passed
SYM895A Reset test Passed
SYM895A FIFO test Passed
SYM895A Loopback test Passed
SYM895A Master test Passed
Diagnostics completed successfully
SCSI port 1 ID: 7
Mar 8 2001 16:13:36 002W Initialization Complete
ATTO FibreBridge 1180
(c) 2001 ATTO Technology, Incorporated.
Firmware version 002W release date Mar 8 2001, 16:13:36 Build 002W
PowerOn SelfTest Completion Status: GOOD
64 Megabytes of RAM Installed.
1 1.0624 Gb/s Fibre Channel Interfaces.
1 LVD SCSI Interface Ports.
Interface 0 World Wide Name = 20 00 00 10 86 10 00 00
FibreBridge Serial Number = "FB1180L000000”
FibreBridge Name = " “
ErrorLog Contents: NO ERRORS
For help, type HELP.
Ready.