Specifications

22
SCSI configuration commands
ScsiPortTaggedQueuing
Specifies whether tagged command queuing is allowed on the SCSI port.
Limits: Enabled allows tagged commands for maximum
performance
Default: enabled
Action:
set ScsiTaggedQueuing [sb [enabled|disabled]]
Information:
get ScsiTaggedQueuing [sb]
SaveConfiguration
ScsiPortWideTransfer
Specifies whether wide SCSI transfers should be negotiated.
Limits: enabled allows wide transfer negotiation Default: enabled
Action:
set ScsiPortWideTransfer [sb[enabled|disabled]]
Information:
get ScsiPortWideTransfer [sb]
SaveConfiguration
ScsiTargets
Returns a list of SCSI devices operational on the referenced SCSI port. Also updates the status of any ‘online’ maps/routes to ‘unavailable’ if a
device is not found or ‘online’ if a device is found.
Action:
none
Information:
ScsiTargets [sb]
Returns: [line count]
[sb] [st] [sl] [device type] [vendor ID] [product ID] [revision] [serial
number]
ScsiTermination
Configures/reports the SCSI internal termination of the SCSI port identified.
Default: enabled
Action:
set ScsiTermination [sb [enabled | disabled ] ]
Information:
get ScsiTermination [sb]
SaveConfiguration
SpeedWrite
When enabled, improves the performance of FCP WRITE commands to SCSI devices attached to the FibreBridge.
Limits: Specify SCSI bus (sb), target (st), LUN (sl) of a mapped SCSI device or (all) for each currently mapped device
Action:
set SpeedWrite [sb st sl|all] [enabled|disabled]
Information:
get SpeedWrite [sb st sl|all]
SpeedWriteDefault
When enabled, SpeedWrite performance enhancement is set as the default for any subsequent SCSI devices mapped manually or via an AutoMap
operation. If disabled, the FibreBridge will not attempt SpeedWrite performance enhancement to newly-mapped SCSI devices.
Action:
set SpeedWriteDefault [enabled | disabled]
Information:
get SpeedWriteDefault