Specifications

20
Fibre Channel configuration
FcInitiator
Allows FibreBridge to operate as an initiator on the Fibre Channel network, an attribute required for features such as Extended Copy.
Actions:
set FcInitiator [enabled | disabled]
Information:
get FcInitiator
SaveConfiguration
FcPortList
Returns a list of available Fibre Channel ports and their current status. Valid status values are
OK
and
Failed.
Actions:
none
Information:
FcPortList
Returns: [line count] [fp] [status]
FcSCSIBusyStatus
Specifies the SCSI status value returned when the FibreBridge is unable to accept a SCSI command because of a temporary lack of resources.
Limits: [busy | qfull] Default: busy
Actions:
set FcSCSIBusyStatus [busy | qfull] I
nformation:
get FcSCSIBusyStatus
SaveConfiguration
FcTargets
Obtains information about every Fibre Channel target device visible to a FibreBridge operating in initiator mode; devices may be used as targets
for initiator mode features such as Extended Copy.
Actions:
none
Information:
FcTargets
Returns: Node Name, FC LUN & inquiry data for each FC device found
FcWWName
Reports the Word Wide Name (WWN) of the Fibre Channel interface. Each FC port has an individual and unique WWN. The least significant 6 bits
of the WWN are used as the Ethernet MAC address.
Limits: Fabric and loop operations are unpredictable if duplicate WWNs are assigned.
Actions:
none
Information:
get FcWWN [PortNumber]
Return: Port n FcWWName= 20 00 00 10 86 nn nn nn
FibreBridgeTargetLUN
Specifies the soft target LUN(s) to be used by the FibreBridge when addressed by the host as a SCSI device.
Limits: Any map coinciding with the user-specified FBTarget LUN must first be set to
offline
before trying to change it. This map will be destroyed upon
power-cycling the FB. Disabling a FibreBridgeTargetLUN for a particular FC port will destroy the map to the FB1180 for that port. The get form reports
all FB Target LUNs currently NOT disabled. Specifying a port returns the status of that port.
Action:
set FibreBridgeTargetLUN [fp] [fl] | [disabled] ]
Information:
get FibreBRidgeTargetLUN [fp]
SaveConfiguration
Returns:
[Line Count]
[fp] [fl]
Performance
Returns the performance data for the Fibre Channel port you specify. Data includes the average rate (MBs per sec.) and number of I/Os measured
over the previous sampling period. Requesting performance data for a FC port which has been disabled or has failed displays an error message.
Reported performance may be affected by FC port and SCSI bus availability and saturation, SCSI device speeds and overall system use.
Action:
none
Information:
get Performance [fp]
Return: [linecount]
; fp
..
MB/s
.............
IO/s
[fp] [mmmm.mmmm] [nnn]
ServicesLUN
Sets and displays the Services LUN for the specified Fibre Channel port. Valid ServicesLUN entries are 0 through (n-1) where n equals the number
of Fibre Channel ports. Valid entries for fl are 0-64. Any map coinciding with a user-specified ServicesLUN must be set to
offline
before trying to
change a ServicesLUN.
Action:
set ServicesLUN [fp] [fl] | [disabled] ]
Information:
get ServicesLUN [fp]
SaveConfiguration
Returns:
[Line Count]
[fp] [fl]