Specifications

16
8.1.2 Maintenance commands
The CLI commands outlined in this chapter may be used to get information or perform functions which
are used in a variety of situations with the ATTO FibreBridge.
FirmwareRestart
Causes the FibreBridge to reboot, then re-initialize its firmware.
Actions:
FirmwareRestart
Information:
none
Reserve
Reservation of the FibreBridge is implicit: once the configuration image is changed by any user of services, the FibreBridge becomes RESERVED.
Executing a SaveConfiguration, RestoreConfiguration or FcRestart RELEASES the FibreBridge so that other services users may access it.
Limits: When FibreBridge services interface is RESERVED, set commands from other users are unavailable.
At least one interface must always have access to the FibreBridge.
Action:
Reserve
Information:
none
Return: [enabled | disabled]
RestoreConfiguration
Restores configuration to either the default configuration or the configuration last saved into non-volatile memory. The saved option will undo any
changes made since the last save.
Actions:
RestoreConfiguration [Default | Saved]
Information:
none
SaveConfiguration
Many commands require a SaveConfiguration command to be executed indicated by the return
Ready. *.
When you invoke SaveConfiguration, the
current configuration is permanently saved in the FibreBridge and the new configuration becomes the active configuration. If a firmware restart is
required to make the requested change permanent, you will see a prompt asking you to confirm the restart. You can override this request by indicating
the override value on the command line. You may make several changes through commands and SaveConfiguration before implementing the restart,
but once you have restarted the FibreBridge, all the command changes created before the restart and save will be implemented. If you select the
restart option, the FibreBridge will execute its complete start up cycle.
Limits: Restart or no Restart parameter is optional
Actions:
SaveConfiguration <Restart| NoRestart>
Information:
none
Returns: [Configuration saved |
Restart is necessary...
Do you wish to restart (y/n)? y
Restarting...]
Zmodem
Allows transfer of a firmware image to or from the FibreBridge using the ZMODEM file transfer protocol.
Limits: available only through the RS232 interface
WARNING After a firmware image is downloaded to the FibreBridge, the image is placed into flash memory.
During this time (about 30 seconds), DO NOT remove power to the FibreBridge or the host until the
READY
message is displayed. The flash may become corrupted if you remove power prematurely.
Actions:
Zmodem [Send filename | Receive]
Information:
none
SaveConfiguration
Returns:
Z
MODEM transfer complete on success
ERROR with status message on failure