Specifications

5
ATTO Technology FibreBridge 1180E/D Installation and Operation Manual
3 ATTO FibreBridge 1180E/D characteristics
The ATTO FibreBridge 1180E/D is a 1 by 1 (one Fibre Channel port with one SCSI port) Fibre Channel-
to-SCSI bridge for standard applications available in vertical or horizontal interface in the embedded
version or a desktop version. The bridge is designed for high throughput enterprise environments and
mission-critical applications.
The form factor and low cost make the
FibreBridge 1180E/D an attractive solution to
convert SCSI devices to Fibre Channel and enable
direct connection to Storage Area Networks
(SANs).
➔
Serverless backup support for SNIA
extended copy command
➔
Support for manual and auto LUN
mapping
➔
Operating system independent
Exhibit 3-1 FibreBridge 1180D component schematic.
Dimensions
Cooling
Environmental requirements
➔
Temperature: 0-40
o
C
➔
Ambient air should not exceed 40
o
C.
➔
Humidity: 10-90% non-condensing
FibreBridge 1180D
A fan draws air at 10 CFM
from the back and sides of the unit and exhausts it
out the front and through the unit’s bottom panel.
Power
FibreBridge 1180E
Power (+5VDC and
+12VDC) is supplied to the through a 4-pin
connector: Amp Part no: 641737-1. The 1180E is
designed to have
±
±±
±
5% tolerance to the power
supply. A switching regulator is used to generate
the 3.3VDC from the 12VDC, requiring 0.75A
at12VDC.
FibreBridge 1180D
requires 3A@5VDC. An AC
power connector and switch are located on the
back of the unit.
Fibre Channel port
The Fibre Channel port can connect the
FibreBridge to either a Fabric or Arbitrated Loop.
➔
1.0625 gigahertz (80 MB/sec.)
➔
Class 2 and Class 3 ANSI Fibre Channel
specifications support
➔
PLDA, Public Loop Login (NL_port) and
Fabric Direct Connect (N_port) support
➔
Full Duplex transmission support
Embedded board Desktop
Length 5.59 in. (14.2 cm) 10 in. (24.4 cm)
Width 3.89 in. (9.9 cm) 7.5 in. (19.05 cm)
Height 2.03 in. (5.1 cm)