User Manual

15
BRUSH ATTACHMENT04
The unit comes with a practical accessory -Brush Attachment to undust the suit and overcoat while
steaming. Observe the following steps to install the accessory to the Steam Nozzle.
1. Make sure the unit is turned off and no steam emitted from the Steam Nozzle.
2. Line up the fabric Brush into upper & lower slots of the steam Nozzle plate as shown in (Fig. 8).
3. Check whether the Brush Attachment is properly installed before start the steaming jobs.
CAUTION :
◆ Do not install the Brush Attachment on the Nozzle Plate while steam emitting.
Lower slot
(Fig. 8)
Upper slot
Brush Attachment