User Manual
14
OPERATING INSTRUCTION03
A. Relling Water
1. Remove the Reservoir by pulling release knob (Fig. 1).
2. Pull the Silicone Sealing Cap out and ll with water(Fig. 2).
3. Replace the reservoir by xing the reservoir to the steamer(Fig. 3) till hearing “ click” sound.
4. Switch on the unit and wait for 22-25 seconds, the steam emits (Fig. 4).
5. Always unplug the unit after steaming jobs nished. The indicator light will be off.
B. Steaming Garment (refer to STEAMING TIPS section)
CAUTION :
◆ Before use, rst check the voltage at home is matched with the unit at 220-240V.
◆ when the water in the reservoir runs out, the Pump is still operating, and this is normal.
Then the unit must be switched off or it may cause damage or accident.
NOTE :
◆ Use only tab, demineralized or ltered water when lling up the water tank. No chemicals
or detergent is allowed to add in the Reservoir.
◆ Always be sure that Steam Nozzle is pointed to garment but not to anybody or pets.
◆ The maximum water level of the Reservoir is 120 ml.
(Fig. 1)
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 5)