SDS

Section 15. Regulatory information
SARA 313
SARA 313 (40 CFR 372.45) supplier notification can be found on the Environmental Data Sheet.
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm.
California Prop. 65
Section 16. Other information
1/13/2016
History
Date of printing
Date of issue/Date of
revision
Version
It is recommended that each customer or recipient of this Safety Data Sheet (SDS) study it carefully and consult
resources, as necessary or appropriate, to become aware of and understand the data contained in this SDS and
any hazards associated with the product. This information is provided in good faith and believed to be accurate
as of the effective date herein. However, no warranty, express or implied, is given. The information presented
here applies only to the product as shipped. The addition of any material can change the composition, hazards
and risks of the product. Products shall not be repackaged, modified, or tinted except as specifically instructed
by Sherwin-Williams, including but not limited to the incorporation of non Sherwin-Williams products or the use
Notice to reader
Date of previous issue
:
:
:
:
Key to abbreviations
:
ATE = Acute Toxicity Estimate
BCF = Bioconcentration Factor
GHS = Globally Harmonized System of Classification and Labelling of Chemicals
IATA = International Air Transport Association
IBC = Intermediate Bulk Container
IMDG = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL 73/78 = International Convention for the Prevention of Pollution From Ships,
1973 as modified by the Protocol of 1978. ("Marpol" = marine pollution)
UN = United Nations
1/13/2016
No previous validation
1
Hazardous Material Information System (U.S.A.)
3
0
2
*
Health
Flammability
Physical hazards
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4
representing significant hazards or risks Although HMIS® ratings are not required on SDSs under 29 CFR 1910.
1200, the preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS®
program. HMIS® is a registered mark of the National Paint & Coatings Association (NPCA). HMIS® materials may
be purchased exclusively from J. J. Keller [phone].
The customer is responsible for determining the PPE code for this material.
Procedure used to derive the classification
Classification
Justification
Skin Irrit. 2, H315
Calculation method
Eye Dam. 1, H318
Calculation method
Skin Sens. 1, H317
Calculation method
Carc. 2, H351
Calculation method
Repr. 2, H361 (Fertility)
Calculation method
STOT RE 2, H373
Calculation method
Date of issue/Date of revision
:
1/13/2016
Date of previous issue
:
No previous validation
Version
:
1
11/12