Specifications

Important: Be sure to connect the RS-232 Serial connection cable

to the same Com Port connection you used to add the tracking

units.

2. From the Administrator program click Shadow Tracker™, click

Maintenance and then click Base Unit Configuration.

3. Refer to your Premier Base System documentation to make the

following Base Unit Configuration settings. (below)

Packet Size: Should be left at the default setting of “70”, unless

instructed to adjust by ATTI Technical Support.

ComPort: Select the Com Port # being used to connect to the

Premier Base from the drop-down menu.

Number of Units: Enter the number of Shadow Tracker™ Premier

units included in your system.

Radio Group: From the drop-down menu select the Radio Group

number listed in your Premier Base System

documentation.

Radio Address: From the drop-down menu select the Base Radio

Administrator program will need to know which Com Port # will be

used to connect to the Premier Base.

1. Connect and power the Premier Base to your computer. (see

Appendix 2)

SOFTWARE SETTINGS

The last step to complete your system is to setup your

Driver/Employee information and Vehicle information into the Shadow

Tracker™ Professional software.

When the data from the Shadow Tracker™ Premier is extracted, the

Driver/Vehicle relationships you define here will be used to display the

GPS tracking data on the map and in reports. For more detailed

information regarding this section, please refer to the Shadow

Tracker™ Professional software manual.

Note: In a Client/Server system, this portion of the setup can be

accessed through the Client system only.

ADDING DRIVER/EMPLOYEE INFORMATION

1. Open the Shadow Tracker™ Professional software.. From the

Windows Desktop click Start, point to Programs, point to Shadow

Tracker™ Professional, click Shadow Tracker™.

2. Log into the program using the default username and password.

Click Start.