Instruction manual

OTHER INFORMATION
7
DO NOT connect any other cable or device to the DATA
connector on the Shadow Tracker™ unit as damage will result.
The other end of the PC Download cable connects to a
standard 9-pin serial connection on your PC. If you cannot
locate this connector or need an adapter then you should
Connect Data
cable
Hardwiring the Shadow Tracker Tracking unit
Direct Connect Cable ( ATTI Model Number A-40254 )
The Direct connect cable should be connected into the POWER
connection of the unit. Next, connect the black w/ white
striped wire to a 12 volt positive power source. This wire
must have power even when the vehicle is turned OFF. Then
connect the remaining black wire to a 12 volt ground source.
Ignition Cable (
To enable ignition switching on your Pro unit, plug the
ignition cable into the ignition connector located on the back
side of the Pro unit. Then connect the red wire into the
vehicles ignition system. To work properly, this connection
must be made at a place where active voltage is on only when
the ignition is on.
Shadow Tracker Pro only
ATTI Model Number A-40275 )