Instruction manual

Note: The unit should only be connected to a '12 volt

center positive' power port. Damage to the unit will

result if connected to a reversed polarity or higher voltage

outlet. If you are not certain that your power outlet is

'12 volt center positive' then do not connect the Shadow

Tracker™ unit at this time. Have the outlet checked by

your local automotive electronics expert or auto

mechanic.

The Shadow Tracker™ unit must remain connected to a

continuous power supply during vehicle movement for

accurate location readings.

Alternative Power Sources

If your vehicle does not have a cigarette lighter, you can still

use the 12 volt battery in your car as the power source for the

Shadow Tracker™. Consult your local car dealer or other

professional automotive dealer for installation.

Note: If the unit does not successfully power up, refer to

the trouble shooting section located at the back of this

manual. The unit power cable should be unplugged when

left for extended periods of time.

Removing the unit for download

Unless you are using the ATTI™ Tracker Extractor or Palm

Extractor utility programs, the Shadow Tracker™ unit must be

removed from your vehicle for the GPS data to be downloaded

into your system. Once the memory is full, the unit will be

unable to continue collecting GPS data until the memory is

cleared. To remove the Shadow Tracker™ unit, disconnect the

Power connector and then the GPS Antenna. Next, remove

DOWNLOADING THE UNIT