User Guide

4
Installation
The brackets for the handles must be installed when
operating for the first time. Please see the following
illustration.
1. Please fix the bracket by tightening the four screws
according to the illustration and your personal habit.
2. According to your selection, dismantle the two screws
on the left or on the right, which fix the bracket of the
handle.
3. Put the two installation holes of the bracket to the two
fixed screw holes of the machine, and then tighten the
dismantled two screws.
4. Put the components of the handle on the bracket to
check if it is suitable.
Button Instructions
11
Power off
Please adjust the power switch to the position “OFF” when the operation
is over. Then the system is into the mode of auto-cold delay shutdown.
And the power will be automatically cut off after the equipment is cooled.
Fault detection
There is the function of automatical detection. If the equipment is out of
order, it can be repaired according to the following methods when there
are failures as follows
A.When “S-E”is displayed on the screen of temperature display with
alarms, which last 20 times, it signifies that there is something
wrong with the sensor or the circuit of the sensor. In this case, you
only need to replace the heating element(integrated structure of
heating element and sensor).
B.When “H-E” is displayed on the screen of temperature display,
there is no hot air in the air nozzle and the digits flicker with alarms,
which last 20 times, it indicates that the heating components are in
the condition of open circuit or the connection of the heaters fails.
If so, reset or replace the heating element.