Installation & Assembly

● Hang the Door
S
t
ep-
g
1.Lift the door up to the track at a
slight angle and rest both wheel grooves
onto the top of the track carefully.
2.Turn the an-jump pad toward the wall
and stop under the track, ghten the
screws.
3.Repeat step-g-1 and step-g-2 on the
other door for a double door installation.
S
t
ep-
h
● Install the Floor Guide
1. Make sure there's a slot at bottom of
the door for the T shape floor guide to be
functional.
2. Rest the door at opening position,
insert the floor guide into the bottom
groove and move toward the opening.
3. Use a level to keep your door upright
and adjust the position of the floor guide.
4. Mark the hole position on the floor.
5. Move the door stopper and door further
to the end for the installation of the floor
guide.
6. Drill two pilot holes at marked position
with 6mm drill bit and insert expansion
anchors. Place door guide in position and
secure it with screws.
7.Move the door back making sure the
door guide is in the bottom groove. Slide
the stopper back in position and fasten
the screws with hex wrench.
8. Repeat step 2 - 7 for the other door, if
none, fasten the screw of the other door
stopper.
Installation completed.
7