User's Manual

User Manual
Document No.
UM-C-002-EN
Date of Revision
2020.08.30
Revision No.
0
QF-001
ATsens Co., Ltd.
96/123
10.6.8.6 How to move the time range using the mouse in the signal display area
Move the mouse wheel up/down to move the time information forward or backward.
10.6.8.7 How to specify noise in the signal display area
In the Full Disclosure Tab, the user can designate an area and set it as a noise section.
Figure 10.150 Noise area designation function
As shown in the figure at the top of [Fig. 10.150 Noise area designation function], select the desired area with
Click & Drag using the left button of the mouse in the Signal Display area and click the right mouse button. A
pop-up box appears as shown in the picture in
There are two items in the pop-up box, “Make a noise Regions” and “Deselect a noise Regions”. When the user
selects “Make a noise Regions”, the figure at the bottom left of [Fig. 10.150 Noise area designation function] As
shown, a red line appears at the bottom of the selection area and is set as the noise area.
To cancel the set noise area, right-click on the set noise area (the area where the red line exists) and select
“Deselect a noise Regions”.
10.6.9 Report Tab
10.6.9.1 Report Tab screen