User's Manual

User Manual
Document No.
UM-C-002-EN
Date of Revision
2020.08.30
Revision No.
0
QF-001
ATsens Co., Ltd.
73/123
The calculation method is as follows.
[Distance (mm/beat) × Time (sec/square) = RR interval (sec/beat)]
1 beat is a value calculated by 1 second (1 second/beat), and the number of beats per second must be calculated to
calculate the heart rate, and to do so, the RR value is 1/RR value.
It uses a conversion factor and converts it to a general unit of minutes (beat/min).
[1 beat/sec x 60 sec/min = 60 beats/min.]
Pause is recognized as pause when no QSR bit for more than 4 seconds occurs.
If the QRS label does not occur in the detail plot and the graph continues flat for 4 seconds, it is recognized as a
pause.
4) Amplitude selection drop box
This is a function to select the voltage of the ECG displayed on the Seconds Strip Plot. The initial Amplitude
setting value is “x1.0” and the user can select and use the desired value among the values presented in the drop
box.
Figure 10.87 Amplitude Selection Drop Box
5) Time Range Selection Drop Box
It is a part that selects the range of the ECG time domain displayed on the Seconds Strip Plot. As shown in [Figure
10.88 Time Range Selection Drop Box], there are 10 sec, 15 sec, and 20 sec values to select the time range.
Figure 10.88 Time Range Selection Drop Box
6) Caliper Button
Figure 10.89 Caliper button
■ Show/Hide Caliper: Show/Hide Caliper button is a button to enable/disable the Caliper function. As shown in
the picture above, when enabled, the button color changes to pink, and when disabled, the button color appears in
white.