Specifications

INTERTEK TESTING SERVICES
FCC ID: UVD20071228001
13
Applicant: Shenzhen MTC Co., LTD Date of Test: January 28, 2008
Model: AT2016
Mode: Modulating
Table 1
Radiated Emissions
Polar
Frequency
(MHz)
Reading
(dBuV)
Pre-Amp
(dB)
Antenna
factor
(dB)
Net at 3m
(dBuV/m)
Limit at 3m
(dBuV/m)
Margin
(dB)
H 38.425 49.8 26.5 9.2 32.5 40.0 -7.5
V 63.046 52.5 26.2 9.3 35.6 40.0 -4.4
H 83.267 52.1 25.8 8.5 34.8 40.0 -5.2
H 377.956 45.3 25.7 23.7 43.3 46.0 -2.7
V 386.438 48.2 25.8 22.4 44.8 46.0 -1.2
V 460.588 44.5 26.0 22.0 40.5 46.0 -5.5
V 980.662 41.8 25.9 23.7 39.6 54.0 -14.4
V 1240.266 39.0 34.8 27.6 31.8 54.0 -22.2
V 1608.357 38.8 35.1 28.3 32.0 54.0 -22.0
Notes: 1. Peak Detector Data unless otherwise stated.
2. All measurements were made at 3 meter. Harmonic emissions not
detected at the 3 meter distance were measured at 0.3 meter and an
inverse proportional extrapolation was performed to compare the signal level
to the 3 meter limit. No other harmonic emissions than those reported were
detected at a test distance of 0.3 meter.
3. Negative value in the margin column shows emission below limit.
4. Horn antenna is used for the emissions over 1000MHz.
5. The smart antenna port was terminated with 10 k and 100 resistor
according to the manufacturer’s specification.
Test Engineer: Billy Li