User guide

Odyssey Access Client User Guide
68  Using the Auto-Scan List Dialog
Using the Auto-Scan List Dialog
To set up or modify an auto-scan list, open the Configuration folder and select
Auto-Scan Lists. The Auto-Scan Lists dialog (Figure 13 on page 68) opens.
Figure 13: Auto-Scan Lists Dialog
You can perform the following tasks in the Auto-Scan Lists dialog:
 Add an auto-scan list
 Remove an auto-scan list
 Modify an auto-scan list
 View the contents of an auto-scan list
Adding an Auto-Scan List
To add an auto-scan list:
1. Open the Configuration folder and select Auto-Scan Lists.
2. Click Add in the Auto-Scan Lists dialog. The Add Auto-Scan List dialog appears.
3. Enter a name for the auto-scan list in the Auto-Scan list name field. You must
fill in this field in before you click OK. You cannot use the same name as
another current auto-scan list.
4. Select networks to add to the auto-scan list from the list of configured networks
listed under Available Networks on the left. Use the right arrows to move
networks from the left to the Networks in list, in priority order
on the right.