User guide

Odyssey Access Client User Guide
54  Infranet Controller Profile Configuration—UAC Networks Only
To set a preferred order of inner EAP protocols:
1. Select one of the inner EAP from the list.
2. Use the arrow button to move the protocol up or down in the list.
3. Repeat this procedure until the list reflects the preferred order.
You can add, remove, or reorder any EAP-PEAP inner protocols from the TTLS
Settings
tab of the Profile Properties dialog.
To remove JUAC as in inner authentication protocol for TTLS:
1. Select JUAC in the list of inner EAP protocols.
2. Click Remove.
You can add, remove, or reorder any EAP-TTLS inner protocols from the TTLS
Settings
tab of the Profile Properties dialog.
Setting JUAC as an Inner Authentication Protocol for PEAP
If you intend to connect to and be authenticated by an Infranet Controller, you must
use JUAC as an inner authentication protocol.
PEAP supports the inner authentication protocols shown in Table 4 on page 49. If
you have PEAP as an outer authentication protocol, JUAC is configured
automatically as an inner EAP protocol.
To set a preferred order of inner EAP protocols:
If you have more than one inner EAP protocol selected, you can order the list of
preferred protocols:
1. Select one of the inner EAP from the list.
2. Use the arrow button to move the protocol up or down in the list.
3. Repeat this procedure until the list reflects the preferred order.
You can add, remove, or reorder any EAP-PEAP inner protocols from the PEAP
Settings
tab of the Profile Properties dialog.
To remove JUAC as in inner authentication protocol for PEAP:
1. Select JUAC in the list of inner EAP protocols.
2. Click Remove.