User guide

Odyssey Access Client User Guide
40  Specifying User Info
 SIM Card—Configure this section when you use a mobile wireless device to
authenticate to a network.
Setting Passwords
The following EAP authentication methods require a password:
 EAP-TTLS with an inner protocol of PAP
 EAP-TTLS with an inner protocol of CHAP
 EAP-TTLS with an inner protocol of MSCHAP
 EAP-TTLS with an inner protocol of MSCHAPV2
 EAP-TTLS with an inner EAP protocol of MD5-Challenge
 EAP-PEAP with an inner protocol of MSCHAPV2
 EAP-MD5-Challenge
 EAP-LEAP
If you configure one the following protocols, you can use a password instead of a
token:
 EAP-FAST
 EAP-PEAP with an inner protocol of GTC
 EAP-PEAP with an inner protocol of POTP
To set a password, select Permit login using password on the Password subtab of
the User
Info tab of the Profile Properties dialog. This lets you enable the
authentication methods that use your password for authentication.
OAC can obtain your password in one of the following ways:
 Select Use Windows password if you want to authenticate to the network using
the same password that you present when you log in to Windows.
 Select Prompt for password to have OAC prompt you when you connect to the
network. In general, this is the most secure option.
NOTE: Do not select this option if you plan to log in to your client device with a
smart card PIN unless your administrator has installed the GINA module. (EE and
FE Only)