User guide

Connecting to a Network  29
Chapter 4: Managing Network Adapters
Connecting to a Network
This section describes how to use OAC to connect to a specific network from the
Adapters dialog (Figure 6 on page 29). The dialog enables you to perform the
following tasks:
 Select a wired or wireless adapter from the list of configured adapters.
 Connect to a specific network.
 Disconnect from the network.
 Scan for available wireless networks.
 Reconnect to the network
Figure 6: OAC Adapter Connection Dialog
Selecting an Adapter
If you or your administrator configured more than one adapter to use with OAC,
select which adapter to use for the network connection.
To select a network adapter:
1. Open the Adapters folder in the sidebar.
2. Select the wired or wireless adapter to use.
Pull-down list
Connection check box