User guide

Opening OAC Manager  11
Chapter 3
Using Odyssey Access Client Manager
This chapter discusses how to use the OAC Manager to configure OAC. Depending
on the edition (license) of OAC that you are using, some sections might not apply
and are identified clearly where they occur.
Opening OAC Manager
Once OAC is installed on your computer, it runs as a Windows service. However, the
OAC user interface, called Odyssey Access Client Manager, might not be open yet on
the desktop.
To open OAC Manager, perform any of the following tasks:
 From the Windows Control Panel, double-click the OAC icon.
 From the system tray, double-click the OAC icon or right-click it and select
Odyssey Access Client Manager. (The system tray is in the lower right corner
of the monitor display where some program icons are shown.)
 From the Windows task bar, select Start > Programs > Juniper Networks >
Odyssey Access Client > Odyssey Access Client Manager.
When OAC runs, the Odyssey Access Client Manager startup screen (see Figure 4 on
page 12) appears.
OAC Logon Credentials
The first time that you open Odyssey Access Client Manager after logging on to
Windows, an OAC dialog box prompts you for your credentials. The credentials
needed depend on how OAC has been configured. For example, you might be
prompted for your username, your username and a password, a soft token, or a
smart card PIN.
Single Sign On
If OAC has been configured for single (automatic) sign on, no logon prompt appears
before Odyssey Access Client Manager opens.