Use and Care Manual

6
4. Wand assembly:
Insert the handle into the extension wand, then insert
the wand into the floor brush or accessory tool.
Adjust the length of the extension wand by pressing the slide
button to adjust the wand length.
5. Tools:
Floor Brush - Can be used on carpets and or hard surfaces. The tool allows you to
retract the bristle brushes when being used on the carpet or rugs but can be extended
when being used on wood or tile surfaces.
Crevice Tool - Use for vent covers, crevices, corners, baseboards, and between
cushions.
Oval Brush - The oval dust brush is used for furniture and between cushions, vent
covers, crevices, corners, and baseboards.
Furniture Nozzle - The furniture nozzle is designed to clean furniture and rugs.
6. Exhaust Filters:
The exhaust cover is easily removed for filter changes:
a. Release the locking mechanism by gently pressing down on one end of the
lo cking bar to release the lo cking m echanism.
b. Grasp the cover in your hand.
c. Ease the upper comer
away from the vacuum
housing.
d. Slide the bottom edge of
the cover away so the
hinges on the bottom
edge of the cover slip out
of the housing.
e. Remove rubber gasket and used filters.
f. Install the new black foam exhaust filter by placing onto the slits and secure
with the rubber gasket. Next, insert the new white cloth exhaust filter over
the rubber gasket.
g. Then, grasp the cover in your hand and insert the lower cover hinges into the
indentations. Be sure the rubber gasket and exhaust filters are resting evenly
on the rim of the cavity. Close the cover and make certain it clicks into place.