Use and Care Manual

9
6. Replace the shake-out bag into the
vacuum.
7. To replace the HEPA dust bag
holder, flip the holder and press tab
until it clicks.
8. Replace the canister lid onto the
Fig.19 vacuum.
2. Pull the tab on the HEPA dust bag Warning: Never overfill the HEPA
holder out slightly and flip upwards. dust bag – replace when bag is full and
(Fig.19) clean the shake-out bag and filter each
time the HEPA dust bag is replaced.
Operating Instructions
Cleaning & Replacing the Cleaning the HEPA Pre-Motor
Shake-Out Bag Filter
Note: Clean the shake-out bag out- Important, Please Note:
doors when changing the HEPA dust The HEPA pre-motor filter will stop
bag. Optimum performance is achieved most of the tiniest dust particles and
by using the HEPA dust bag with the airborne allergens from re-entering the
shake-out bag decreasing the need for air you breathe. In fact it stops 99.97%
washing the shake-out bag. of all particles as small as 0.3 microns-
Cleaning the Shake-Out Bag when many times smaller than a human hair!
Used with the HEPA Dust Bag: Because of this incredible filtration
1. Remove the shake-out bag, holding performance, the HEPA pre-motor filter
the handle at the bottom of the bag, will accumulate many fine dust particles
shake outdoors vigorously over a that are difficult to see. Be assured that
garbage receptacle until there is no the HEPA pre-motor filter is doing the
more dust. job. Clean the HEPA pre-motor filter
2. Inspect shake-out bag regularly for after each use as described in this
tears or damage .Replace shake- section.
out bags if damage or tears are present. 1. Remove the shake-out bag from the
Cleaning the Shake-Out Bag when canister. The HEPA pre-motor filter
Used Alone: is located underneath the shake-out
1. Remove the shake-out bag, empty bag. Pull up near the tabs on the
motor filter, lift the form the
vigorously out doors until there is no sides of the HEPA filter. This is a press fit system.
Warning: To reduce the risk of electric shock, the power cord must be
disconnected before removing the dust bag, shake-out bag,
changing the filters or performing maintenance or trouble-
shooting checks.