Use and Care Manual

4
5. Waist Band 19. Crevice Tool
6. Shoulder Straps 20. Blower Port
7. Back Board Panel 21. Pet Hair Remover
8. Carry Handle 22. Floor to Carpet Brush
9. Hose Inlet 23. Exhaust Filter
10. Canister Lid 24. Blowing Attachments
11. Flexible Hose 25. HEPA Dust Bag
12. Flexible Hose handle 26. Shake-Out Bag
13. Variable Suction Control 27. HEPA Pre-Motor Filter
14. Telescopic Tube Release Button 28. Turbo Brush (Not Pictured)
Operating Instructions
Warning: To reduce the risk of electric shock, the power cord must be
disconnected before removing the dust bag, shake-out bag,
changing the filters or performing maintenance or trouble-
shooting checks.
Assembling Your Vacuum 5 The cardboard face of the new bag should
Cleaner rest securely in the dust bag cover guides.
Note: Always remove the power plug (Fig. 3)
from the wall outlet before attaching
or removing accessories.
Inserting the HEPA Dust Bag
Note: This unit can be used with the shake-
out bag alone, however it must be cleaned Fig. 3
after every use if there is no HEPA dust bag 6 Ensure that the shake-out bag is in place.
installed. (Fig. 4)
Important: Do NOT use the vacuum with
out all filters, shake-out bag, and with or without
HEPA dust bag in place.
1. Unplug the power cord and
remove the flexible hose.
2. To open the canister lid, press on the canister
lid tabs on each side of the unit and lift canister lid.
(Fig.1)
Fig. 4
7 Flip the HEPA bag holder over, pressing
the tab on the bag holder until it clicks,
then replace the canister lid.
8 The canister lid can be replaced on the
Fig.1 unit with the hose opening on the right
3. Pull the tab on the HEPA dust bag holder out or left, as per your preference. (Fig 5)
slightly and flip upwards.(Fig 2)