Use and Care Manual

! 5
Cleaning the HEPA Pre-motor Filter
1.
Press/pinch both tabs and pull upwards on filter.
2.
Tap out the contents of the HEPA filter over a garbage can.
3.
If necessary, thoroughly rinse the HEPA filter using regular tap water. Then shake off any excess
water and allow to dry completely before reinserting it.
4.
To reinsert, place filter over the tabs and press down. You should hear two "clicks" if installed
correctly. (Fig. 5)
Fig. 5
Caution: The HEPA pre-motor filter will stop most of the tiniest dust particles and airborne allergens
from re-entering the air you breathe. In fact, it can stop 99.97% of most particles as small as 0.3
microns. Over time, this HEPA pre-motor filter will accumulate fine dust particles. Clean or replace the
HEPA pre-motor when you see a lot of dust and dirt embedded.
Cleaning the Exhaust Filter
1.
Pull up and hold the exhaust tab and pull out the exhaust cover. (Fig. 6)
2.
Remove the exhaust filter.
3.
As necessary, hand or machine wash the cloth filter and let dry before reinserting it.
Fig. 6